Bandsaw Table Insert (For cast Iron Table Only )
This was machined from aircraft aluminum.
Jigsaw Table Insert (Fit's aluminum & cast iron tables)
Lathe Tool Support For Turning (Made to fit Mark V & 10ER)
Just remove your standard tool rest and insert the support into your holder. Install your gouge/scraper and pull your carriage back and forth with your hands.
To turn a clean taper offset your tailstock center and cut the same way as straight turning.
Picture on left is new revised holder with counter sunk cap head screws
and a "V" notch machined on center for extra knife support. Picture on right is old proto-type.
Stainless Steel 10E/10ER Quill Feed Handle
Machined from stainless and polished to a mirror finish.
Triple With Machined &Polished Hub